| Image | Item | Location | Available | |
|---|---|---|---|---|
40-pin FPC Extension Board + 200mm Cable Give your 40 pin, 0.5mm pitch, devices a strrrreeeetch with this extension board. This 40pin FPC extension board has two 40-pin flex connectors (both are bottom contact type), and an extension cable to add ~22cm (20cm cable plus 2cm board) Each order comes with one board a 20cm long, 40-pin 0.5mm pitch FPC cable and board. Works great with our 40pin TFTs! | 2/2 | |||
PIR (motion) sensor PIR sensors are used to detect motion from pets/humanoids from about 20 feet away (possibly works on zombies, not guaranteed). This one has an adjustable delay before firing (approx 2-4 seconds), adjustable sensitivity and we include a 1 foot (30 cm) cable with a socket so you can easily reposition the sensor or mount it using the two holes on either side. Runs on 5V-12V power (if you need to run it off of 3V you can do that by bypassing the regulator, but that means doing a bit of soldering). Digital signal output is 3.3V high/low. Sensing range is about 7 meters (120 degree cone).For a full tutorial with wiring diagrams, CircuitPython and Arduino code examples and project ideas, PIR sensor tutorial page! | 1/1 | |||
LilyPad Arduino Simple Board This is the LilyPad Arduino Simple Board. It’s controlled by an ATmega328 with the Arduino bootloader. It has fewer pins than the LilyPad Arduino Main Board, a built in power supply socket, and an on/off switch. Any of our LiPo batteries can be plugged right into the socket. The Simple board is designed to streamline your next sewable project by keeping things simple and giving you more room to work and eliminating the need to sew a power supply. This revision does away with the ISP header and adds a charging circuit based on the MCP73831 IC. LilyPad is a wearable e-textile technology developed by Leah Buechley and cooperatively designed by Leah and SparkFun. Each LilyPad was creatively designed to have large connecting pads to allow them to be sewn into clothing. Various input, output, power, and sensor boards are available. They’re even washable! Not sure which Arduino or Arduino-compatible board is right for you? Check out our Arduino Buying Guide! Note: A portion of this sale is given back to Dr. Leah Buechley for continued development and education of e-textiles and also to Arduino LLC to help fund continued development of new tools and new IDE features. Note: Because of the added battery charging circuitry the Simple is unable to power a device from the FTDI header meaning that the Bluetooth Mate, for instance, is no longer plug'n'play compatible. Features 50mm outer diameter Thin 0.8mm PCB | 1/1 |